Re: X( WARNING TP-Link TL-WR703N v1.7. X(

I decided to just go ahead and try step number 8, but I can't seem to mount the USB. Perhaps it's not really working the way it should...

> root@OpenWrt:~# cd /mnt/usb
> -ash: cd: can't cd to /mnt/usb

So nothing to cd to. Let's see what 'dmesg' gives me. Device rebooted with USB plugged in:

---

[ 9.610000] PPP generic driver version 2.4.2
[ 9.860000] ip_tables: (C) 2000-2006 Netfilter Core Team
[ 10.080000] NET: Registered protocol family 24
[ 10.100000] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
[ 10.110000] ehci-platform ehci-platform: Generic Platform EHCI Controller
[ 10.110000] ehci-platform ehci-platform: new USB bus registered, assigned bus number 1
[ 10.150000] ehci-platform ehci-platform: irq 3, io mem 0x1b000000
[ 10.170000] ehci-platform ehci-platform: USB 2.0 started, EHCI 1.00
[ 10.170000] hub 1-0:1.0: USB hub found
[ 10.170000] hub 1-0:1.0: 1 port detected
[ 10.200000] nf_conntrack version 0.5.0 (456 buckets, 1824 max)
[ 10.430000] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
[ 10.510000] usb 1-1: new high-speed USB device number 2 using ehci-platform
[ 14.290000] device eth0 entered promiscuous mode
[ 14.400000] eth0: link up (100Mbps/Full duplex)
[ 14.400000] br-lan: port 1(eth0) entered forwarding state
[ 14.410000] br-lan: port 1(eth0) entered forwarding state
[ 16.410000] br-lan: port 1(eth0) entered forwarding state

---

Unplugged the USB and tried again:

---

[ 102.600000] usb 1-1: USB disconnect, device number 2

---

Plugged the USB back in:

---

[ 113.140000] usb 1-1: new high-speed USB device number 3 using ehci-platform

---

So what am I doing wrong? Something simple or is the USB broken?