I'm still having similiar issues, Not able to get the files to be recognized on usb. I extracted the install folder and put it in usb and chose correct version of the .bin for my 3040 v2.3 from the website you mentioned.
I looked in /dev and /mnt but haven't seen anything.
dmesg showed this.
[ 868.920000] usb 1-1: USB disconnect, device number 2
[ 872.210000] usb 1-1: new high-speed USB device number 3 using ehci-platform
(pretty sure this is when I unplugged it and plugged it back in)
I'm not familiar with ssh commands so I wasn't sure if there was something I could type to make it register.
it appears that piratebox didn't install again as it turned my wifi off during the openwrt firmware upgrade. I went into the network config and changed the disable from 1 to 0 but the name that popped up for the ssid is openwrt
I could be looking in the complete wrong place but I have to say, it's been kind of fun learning all this stuff! I actually managed to get opkg to work correctly. I was getting the error wget returned 1 but I fixed it. felt very accomplished haha.
Thanks for being so patient with me, I appreciate it.
I looked in /dev and /mnt but haven't seen anything.
dmesg showed this.
[ 868.920000] usb 1-1: USB disconnect, device number 2
[ 872.210000] usb 1-1: new high-speed USB device number 3 using ehci-platform
(pretty sure this is when I unplugged it and plugged it back in)
I'm not familiar with ssh commands so I wasn't sure if there was something I could type to make it register.
it appears that piratebox didn't install again as it turned my wifi off during the openwrt firmware upgrade. I went into the network config and changed the disable from 1 to 0 but the name that popped up for the ssid is openwrt
I could be looking in the complete wrong place but I have to say, it's been kind of fun learning all this stuff! I actually managed to get opkg to work correctly. I was getting the error wget returned 1 but I fixed it. felt very accomplished haha.
Thanks for being so patient with me, I appreciate it.