Mathias Hi----------you are my ray of hope---------------Here is were I am at------------------I installed the openwrt firmware-----------but now when I want to open my setup page using the ip 192.168.1.1--------------i get (unable to connect)---------the unit is ok i know that as it powers up etc lights blinking. Should I be able to access the setup page like normal?. I am runing the following command in telnet ----------------with mongoose and putty running--------------I rename the firmware to bbb.bin or should I use DD.exe to do it. Any I run wget 192.168.1.2 bbb.bin and Im getting cannot access the host etc etc stuff
Were do I put the firmware in what folder so I can access it. Its in download right now and so is mongoose. When I run mongoose I see the index @ 192.168.1.2.50:8080. Thing is I am all confused and I know Im so close to cracking it. Perhaps you could clarify it all a bit.
Were do I put the firmware in what folder so I can access it. Its in download right now and so is mongoose. When I run mongoose I see the index @ 192.168.1.2.50:8080. Thing is I am all confused and I know Im so close to cracking it. Perhaps you could clarify it all a bit.