Hi there,
Yeah I did it as you mentionned. Find out that the drivers were not working so well.
After trying and trying again I was able to launch the serial access, to access to hornet>, upload the original firmware, erase the blocks and then with the last command came the errors, it's like booting infinetly, it never goes after "reading firmware" or something like that, then come back to "Auto boot in 1 sec" and do it as a loop.
My MR3040 is a V2 maybe something specific to do ( with the switch button or I don't know), I did use thé correct image from openwrt web site so..
Thanks for your time Matthias!
Yeah I did it as you mentionned. Find out that the drivers were not working so well.
After trying and trying again I was able to launch the serial access, to access to hornet>, upload the original firmware, erase the blocks and then with the last command came the errors, it's like booting infinetly, it never goes after "reading firmware" or something like that, then come back to "Auto boot in 1 sec" and do it as a loop.
My MR3040 is a V2 maybe something specific to do ( with the switch button or I don't know), I did use thé correct image from openwrt web site so..
Thanks for your time Matthias!