Re: Failed to Install MR3020 only OpenWRT - what now?

I also tried now: [forum.piratebox.cc]

But here i recieve:

/etc/init.d/boot start
mount: mounting debugfs on /sys/kernel/debug failed: Device or resource busy

dmesg | tail -n 20
[ 30.730000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp), (dfs_cac_time)
[ 30.740000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A, 3000 mBm), (N/A)
[ 30.750000] cfg80211: (5170000 KHz - 5250000 KHz @ 80000 KHz), (N/A, 1700 mBm), (N/A)
[ 30.750000] cfg80211: (5250000 KHz - 5330000 KHz @ 80000 KHz), (N/A, 2300 mBm), (0 s)
[ 30.760000] cfg80211: (5735000 KHz - 5835000 KHz @ 80000 KHz), (N/A, 3000 mBm), (N/A)
[ 30.770000] cfg80211: (57240000 KHz - 63720000 KHz @ 2160000 KHz), (N/A, 4000 mBm), (N/A)
[ 31.220000] loop: module loaded
[ 31.270000] ip_tables: (C) 2000-2006 Netfilter Core Team
[ 31.450000] nf_conntrack version 0.5.0 (455 buckets, 1820 max)
[ 31.680000] ip6_tables: (C) 2000-2006 Netfilter Core Team
[ 31.950000] batman_adv: B.A.T.M.A.N. advanced 2013.4.0 (compatibility version 14) loaded
[ 35.980000] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 35.990000] device eth0 entered promiscuous mode
[ 35.990000] ADDRCONF(NETDEV_UP): br-lan: link is not ready
[ 36.510000] eth0: link up (100Mbps/Full duplex)
[ 36.510000] br-lan: port 1(eth0) entered forwarding state
[ 36.520000] br-lan: port 1(eth0) entered forwarding state
[ 36.520000] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[ 36.540000] ADDRCONF(NETDEV_CHANGE): br-lan: link becomes ready
[ 38.520000] br-lan: port 1(eth0) entered forwarding state


mount /dev/sda1 /mnt
mount: mounting /dev/sda1 on /mnt failed: No such file or directory