Hi Matthias thanks for the fast reply
Well... the problem is i can't connect to my piratebox anymore... i assume that is a dhcp problem? after looking on troubleshooting page, i think reflash would be that best answer, then i've to use failsafe mode right?
following the steps
1 - Connect the MR3020 to your computer via Ethernet. OK
2 - Set up your of the computer to 192.168.1.2 OK
3 - Start to ping 192.168.1.1 (this is the failsave IP) infinitive OK
4 - Power the MR3020 on and when the WPS Button starts to blink , push it (it will blink faster) OK
5 - You see the ping getting response OK
6 - telnet 192.168.1.1 FAIL
when i try to use putty with telnet i keep getting this message
PuTTY Falta Error
Network error: Connection refused
it only works with ssh option ... what i'm doing wrong?
Well... the problem is i can't connect to my piratebox anymore... i assume that is a dhcp problem? after looking on troubleshooting page, i think reflash would be that best answer, then i've to use failsafe mode right?
following the steps
1 - Connect the MR3020 to your computer via Ethernet. OK
2 - Set up your of the computer to 192.168.1.2 OK
3 - Start to ping 192.168.1.1 (this is the failsave IP) infinitive OK
4 - Power the MR3020 on and when the WPS Button starts to blink , push it (it will blink faster) OK
5 - You see the ping getting response OK
6 - telnet 192.168.1.1 FAIL
when i try to use putty with telnet i keep getting this message
PuTTY Falta Error
Network error: Connection refused
it only works with ssh option ... what i'm doing wrong?