Re: Found a MR3040 - Can't Seem to Access it

Hi,
thanks for posting here! It is very difficult to give valuable support on twitter.

When you are writing:

Quote

I should mention - all lights are on with the router.

Do you mean that all lights are steady online or do they all go off and on all the time (which is an indicator for a not working firmware image).

Quote

If I plug in via ethernet cable, I can't get a local IP address to SSH into the device according to this guide.

This guide is only helpful If you really want to start from the beginning or get back to TPLink software for various reasons. If you want to start over, it is better to try to reflash using the normal onboard utilities.

Let's start with a few questions:

- You are writing, that you are not getting an IP during ethernet or wifi connection. Did you try to setup a static IP on wifi and/or ethernet connection. The setup would be IP 192.168.1.2 netmask 255.255.255.0
- Did you leave the USB stick with installed piratebox in the box?
- Assuming the device is running some sort of OpenWrt brand. Did you tried to get access via telnet and failsafe mode? Reflash via failsave mode & USB ; Reflash via failsave mode & without USB

edit:
if we really can't get any access to the box, the correct guide for reflashing via tftp & serial cable would be: Recover a bricked MR3020 . (you can leave out the resistor - just connect TX,RX,GND)

best regards Matthias