Heres what i did to flash the buffalo wzr-600dhp
downloaded and flashed dd-wrt for the wzr-600 using the "buffalo_to_ddwrt_webflash-MULTI.bin" file found on this [www.dd-wrt.com] page
From there i tried to ssh in but could not get it working nor could i get winscp working either. Also i could not flash any other firmware labeled wzr-600dhp either. So then i noticed that the above mentioned dd-wrt firmware labeled my router as the wzr-hp-ag3000h in the webGUI
After noticing what my router was now labeled as i went to this [dd-wrt.com] page and dowlned the file labeled as "wzr-hp-ag300h-dd-wrt-webupgrade-MULTI.bin" and used the webGUI to upgrade.
After the flash/upgrade was complete i was able to ssh in and follow the instructions for flashing openwrt using putty's wget and mtd-r write commands found in the openwrt wiki for the wzr-600dhp.
Once all that was completed the Piratebox was sucessfully installed.
downloaded and flashed dd-wrt for the wzr-600 using the "buffalo_to_ddwrt_webflash-MULTI.bin" file found on this [www.dd-wrt.com] page
From there i tried to ssh in but could not get it working nor could i get winscp working either. Also i could not flash any other firmware labeled wzr-600dhp either. So then i noticed that the above mentioned dd-wrt firmware labeled my router as the wzr-hp-ag3000h in the webGUI
After noticing what my router was now labeled as i went to this [dd-wrt.com] page and dowlned the file labeled as "wzr-hp-ag300h-dd-wrt-webupgrade-MULTI.bin" and used the webGUI to upgrade.
After the flash/upgrade was complete i was able to ssh in and follow the instructions for flashing openwrt using putty's wget and mtd-r write commands found in the openwrt wiki for the wzr-600dhp.
Once all that was completed the Piratebox was sucessfully installed.