A few months ago I setup an MR3020 as a piratebox.
I then removed the USB and lost it, because I'm awesome like that. So now it's not handing out IP addresses.
I figured since I didn't really understand what I was doing when I set the thing up, I would just wipe it, put the stock firmware back on and start from scratch. Here's my problem, I can't access the damn thing.
I don't know what the IP addresses were when I set it up, don't have the passwords and cant remember how I configured the thing.
I was able to get into the failsafe mode by hitting the button when it powers on. I can then use telnet to connect to it using 192.168.1.1. This is where I'm stuck. I tried to enable SSH by using the passwd command, but the filesystem is read-only. I tried "mount_root", but it shows error messages saying that some file doesn't exist.
Does anyone know of a way to connect to this and install the original firmware?
Any help would be great,
Thanx
I then removed the USB and lost it, because I'm awesome like that. So now it's not handing out IP addresses.
I figured since I didn't really understand what I was doing when I set the thing up, I would just wipe it, put the stock firmware back on and start from scratch. Here's my problem, I can't access the damn thing.
I don't know what the IP addresses were when I set it up, don't have the passwords and cant remember how I configured the thing.
I was able to get into the failsafe mode by hitting the button when it powers on. I can then use telnet to connect to it using 192.168.1.1. This is where I'm stuck. I tried to enable SSH by using the passwd command, but the filesystem is read-only. I tried "mount_root", but it shows error messages saying that some file doesn't exist.
Does anyone know of a way to connect to this and install the original firmware?
Any help would be great,
Thanx