Hey Sam,
it seems you missunderstood the howto :)
During the first connection with the fresh unpacked mr3020, you do a simple connect without any aditional changes. Leave your network-configuration to dynamic/dhcp . The MR302 comes with the setup-ed 192.168.0.254 - and you can set an IP address twice in a network
After you flashed the image once with the openwrt image, you are going to need to change the network-config to a static one, on your computer.
no worries!
regards Matthias
it seems you missunderstood the howto :)
During the first connection with the fresh unpacked mr3020, you do a simple connect without any aditional changes. Leave your network-configuration to dynamic/dhcp . The MR302 comes with the setup-ed 192.168.0.254 - and you can set an IP address twice in a network
After you flashed the image once with the openwrt image, you are going to need to change the network-config to a static one, on your computer.
no worries!
regards Matthias