Re: How to trigger the post install steps.

Thanks, Matthias for super swift help.

My usb stick shows auto_package_done.

So I cleared off the stick and re-extracted the files from install_piratebox.zip. I then replace the stick in the router, turn it vack on and run the /bin/box_installer_start.sh and the router reboots but there the only change on the USB stick is that auto_package get renamed to auto_package_done

Can I just reset the entire box to a basic clean install? There's little or no customisation it ATM.

Edit - By that I mean re-run the install as if I was flashing from the default stock ROM. A full wipe and re-install