Re: Bricked?
i have the ttl to usb and the mr3040v2 but i cannot find the 3040 wiring diagram, only the 3020 [gyazo.com] [gyazo.com] TL-MR3040 USB-UART GND GND RX TXD TX RXD correct? and is the mr3020 and the...
View ArticleRe: Bricked?
Serial console pinout for MR3040 can be found here => [wiki.openwrt.org] under "Serial console"
View ArticleRe: Bricked MR3040
So i rebricked my bricked mr3040. It was bricked "normally", and figured I could get into uboot by using a serial connection because the power led and all the leds were flashing consecetuvely. I...
View ArticleUnbricked...? No Wireless connectivity .-. No Mac
i just unbricked my 3040 using ttl to usb and now it only works on lan, it has no wireless access. on factory fw it works fine...
View ArticleForum error: The kareha imageboard is not fully configured.
Hi: I'm very close! Got it all working, except for forum. I'm using MR-3020 During post-install, got error message, Imageboard admin password: sed: /opt/piratebox/share/board/config.pl: No such file...
View ArticleRe: Unbricked...? No Wireless connectivity .-.
Hmm this is weird... i have no mac. [gyazo.com] how do i set my mac?
View ArticleRe: Forum error: The kareha imageboard is not fully configured.
Hi, that sounds strange. Can you please insert a copy from the output of the commands listed here: [piratebox.cc] That helps us to get some basic idea about the status of your box. best regards Matthias
View ArticleRe: Bricked MR3040
well, did you tried to look into your box, using the serial cable, again? Sometimes you can see a meaningful message. Which openwrt image did you use for flashing?
View ArticleRe: Unbricked...? No Wireless connectivity .-.
Mh, you mean that the latest PirateBox image does not work on your MR3040, correct? Can you post the output of this commands please: [piratebox.cc] Which MR3040 version do you have? Is it a v2 or a v1?
View ArticleZsun OpenWRT
Got my Zsun in today. Followed this guide to install OpenWRT Connected and was able to get my AP running and get it connected to my router as a client. So now its running as an AP and a client....
View ArticleRe: Unbricked...? No Wireless connectivity .-.
it is V2, how do I get the output of the commands?
View ArticleRe: Bricked MR3040
there is no serial connection possible, so no messages. But, you were right about checking the firmware version. I'm a total idiot, I flashed it with v1 while the router is v2. FUBAR?
View ArticleRe: Unbricked...? No Wireless connectivity .-.
did you tried to use the static IP 192.168.1.2 on your ethernet port and try telnetting into 192.168.1.1?
View ArticleRe: Bricked MR3040
so, if you haven't messed it up completely, you should still be able to use a serial adapter and see uboot messages, don't you?
View ArticleRe: Bricked MR3040
In that case I have messed it up completely, because when I hook up the serial adapter, I get a connection timeout, no uboot, nothing.
View ArticleRe: Unbricked...? No Wireless connectivity .-.
i can connect fine and everything but how do i save the commands to show you the results?
View ArticleRe: Unbricked...? No Wireless connectivity .-. No Mac
Just copy/paste the output of the commands and upload them to a paste service [paste.bubblesort.me]
View Article