So after giving up on the mr3420 I went and purchased a MR3020. I did my network edit through ssh and after that I could no longer connect to my future PB via ssh through wifi or direct connect to pc via Ethernet cable. I am quit sure that there was no spelling errors in the edit due to the fact that I copy and pasted it straight from the tutorial.
Is there a trick to it or do I need to connect a serial cable and try again.
If I do need to connect via serial can someone point me in the right direction as to how I would go about "re-flashing" or "re-editing" it so that I can start over and redo everything?
Is there a trick to it or do I need to connect a serial cable and try again.
If I do need to connect via serial can someone point me in the right direction as to how I would go about "re-flashing" or "re-editing" it so that I can start over and redo everything?